Add and Remove Policy Sections
- Open a policy, then click 'ADD/REMOVE SECTION(S)' at the foot of the left-hand pane.
A policy only carries the sections you give it. This dialog is where you choose them. It lists every section the policy's operating system supports, with a check box each, under the same two headings the section tree uses.

The dialog
The dialog is headed 'Add / Remove Sections'. The entries are grouped under 'IT OPERATIONS' and 'SECURITY OPERATIONS'. A ticked box means the section is in the policy; clearing it takes the section out.
For a Linux policy the dialog lists:
| Heading | Sections offered |
| IT OPERATIONS | Procedures, Monitors, Remote Tools, Client Access Control, Client Proxy, XCS Proxy, Updates, UI Settings, Logging Settings |
| SECURITY OPERATIONS | Antivirus, Xcitium Verdict Cloud |
'General' and 'Associated Devices' are not in the list. They are always part of a policy and cannot be removed.
Buttons
| Button | Description |
| SAVE | Applies your choices. Sections you ticked appear in the tree; sections you cleared are taken out of the policy. |
| CANCEL | Closes the dialog and leaves the policy as it was. |
Add a section to a policy
- Open the policy.
- Click 'ADD/REMOVE SECTION(S)' at the foot of the left-hand pane.
- Tick the sections you want.
- Clear the check box of any section you want to take out.
- Click 'SAVE'.
- Click the new section in the tree and fill in its settings. Until you do, it carries an orange warning triangle reading 'Not configured'.
Note: the list of sections on offer changes with the operating system. See Policy Sections by Operating System.
Note: clearing a check box and clicking 'SAVE' discards whatever that section held.
