Comodo One

• Introduction To Network Assessment Tool
  • Quick Start Guide
  • System Requirements
  • Download And Install Network Assessment Tool
  • Configuration Wizard
  • The NAT Admin Console
• Network Management
  • Add Networks
  • Credentials Management
• Run Network Assessment Scan
  • View Scan Progress
  • View Scan Logs
• Generate Reports
• Configure Network Assessment Tool
• Feedback
• About Comodo Security Solutions

Add Networks

Networks can be added using any of the following methods:

• Domains - Add Active Directory domains by specifying their DNS name and NetBios name. See Add Domains for more details.

• Workgroups – Add workgroups by specifying the name of the workgroup. See Add Workgroup for more details.

• IP Address Range(s) – Endpoints to be scanned can be specified by defining the IP range. See Add IP Address Range for more details.

Add Domains

• You can add an AD domain by specifying its DNS domain name and NetBios name.

• If you want to scan only selected endpoints in the domain, you can addOrganization Unit (OU) filters.

• Admin login details for the AD server need to be added in the 'Credentials' interface and mapped to the domain. See Credential Management for more details.

To add a domain

• Click 'Scanning Methods' from the menu bar and select the 'Active Directory' tab

• Ensure that the 'Enable Active Directory Scanning' check-box is selected

• Click 'Add Domain'

• Enter the DNS name and NetBios name in the respective fields.

• If you want to enable the domain for scanning, select the 'Enable' checkbox beside the domain name

The domain will be added to the list.

• To remove a domain click the thrash can icon
  

To add an OU filter

• Click 'Add OU Filter'

A new row will be added to the list of filters.

• Enter the OU filter in the new row.

• If you want to enable the filter, select the 'Enable' check-box
  

The filter will be added to the list.

• To remove a filter click the thrash can icon 
  

Adding Workgroup

In order to scan endpoints in a workgroup, 'Workgroup Scanning' has to be enabled in NAT. You can add a workgroup by  specifying its name. You must then add an admin password for the domain n the 'Credentials' area and map it to the workgroup. See Credential Management for more details.

• Click 'Scanning Methods' from the menu bar and select the 'Workgroup' tab

• Ensure that 'Enable Workgroup Scanning' check-box is selected

• Click 'Add Workgroup'

• Enter the name of the workgroup you want to add
  

• Click the trash can icon to remove a work-group
  

Adding IP Address Range

To add an IP Address Range

• Click 'Scanning Methods' on the menu bar and select the 'IP Address Range' tab

The list of IP address ranges added to NAT will be displayed.

• Ensure that 'Enable IP Address Range Scanning' checkbox is selected

• Click 'Add IP Range'

A new row will be added to the list of IP Address ranges.

• Enter the start IP address and the end IP address in the respective fields

• Enter a description for the IP address range in the textbox that appears below the row.

• Enter the time out period for WMI so as to skip scanning the endpoints that are not responsive for the period specified in this field.
  

• Click 'Save' at the right of the row to add the IP address range.

The next step is to map login credentials to the IP address range.

• Click 'Add Credential' at the right of the row.

The 'Set Credentials' dialog will appear with a list of credentials added to NAT.

• Click 'Ok' after choosing the credentials to apply to the IP address range

• Click the trash can icon  to remove an address range