Comodo One

• Introduction To Network Assessment Tool
  • Quick Start Guide
  • System Requirements
  • Download And Install Network Assessment Tool
  • Configuration Wizard
  • The NAT Admin Console
• Network Management
  • Add Networks
  • Credentials Management
• Run Network Assessment Scan
  • View Scan Progress
  • View Scan Logs
• Generate Reports
• Configure Network Assessment Tool
• Feedback
• About Comodo Security Solutions

Credentials Management

• You need to provide admin login details for your target networks in order for NAT to scan them.

• You can map credentials to specific networks. NAT uses the appropriate credentials to access each network.

The 'Credentials' interface allows you to add and map login credentials for the networks.

• Click 'Credentials' on the menu bar
  

See the following sections for more details:

• Adding login credentials

• Mapping credentials to a network

To add a new login credential

• Click 'Add new Credential' from the 'Credentials' interface

The 'Set new credential' dialog will open.

• Click 'OK' to add the credential

• Repeat the process to add more credentials

• Click 'Edit' at the right of the row to edit a credential and enter the new values in the 'Set new credential' dialog. The process is similar to adding a new credential.

• Click the thrash can icon to remove a credential

To add a new mapping of credential to a network

• Click 'Add new Mapping' in the 'Credentials' interface:

The 'Apply Mapping Rule' wizard will open.

• Mapping Type - Choose the type of the network to which the credentials are to be mapped. The available options are 'IP Range', 'Domain' and 'Workgroup'. 

• Domain - The drop-down displays the networks added to NAT and fall under the type chosen from the 'Type' drop-down. Choose the network to which the credential is to be applied 

• Click 'Ok' 

The network will be added to the 'Mappings' list, mapped with the default credentials that was specified through the initial configuration wizard.

• Click 'Add Credential' at the right end of the row, to change the credential for the network.
  

The 'Set Credentials' dialog will appear.

• Select the credential(s) to be applied to the network and click 'Ok'.

• To add new credential(s) to the same network, click 'Add Credential' at the right end of the row and repeat the process.

• Click 'Edit' at the right of the row, to edit the network and change the network type and the network. The process is similar to adding a network mapping.

• Click the trash can icon to remove a mapping from the list.